These high-volume centrifuges Z 446 and Z 446 K achieve a throughput of 68 x 15 ml conical tubes or 28 x 50 ml conical tubes at a max.RCF of 3434/4346 xg. If higher speeds are required, we also offer e.g. an angle rotor with a max. RCF of 14532/16022 xg for 10 x 50 ml. The fixed-angle and swing-out rotors are suitable for almost all aplications in everyday use in clinical, industrial and research laboratories.

The DT Series of analytical and high precision balances from LabPRO delivers the accuracy and performance required in a host of laboratory, industrial and educational applications. 

LabPRO products are specially designed to offer high performance with Swiss accuracy yet with economical value. The new LabPRO Electronic pipettes are as easy to use as the mechanical micropipettes with only 2 buttons and 4 essential pipetting modes: Pipet, Repetitive, Mix and Reverse.

LabPRO products are specially designed to offer high performance with Swiss accuracy yet with economical value. The new LabPRO high precision micropipette is the only mechanical pipette that offers both lock/unlock mechanism and tip ejection system in one.

The Burst Tester is used as a multi-directional test to identify failure in the direction showing least resistance. This test shows the physical strength and fiber bond. Different models are available for paper, board or textile. This instrument is also used for other applications such as plastic, rubber, aluminum and felts. The sample is pneumatically clamped, the rubber membrane is pushed upwards by hydraulics. The force at fracture is recorded.

Insert Your Sample and Test. The Horizontal Tensile Tester tests the tensile strength and elongation of a sample. After placing the sample the sensor detects the sample and the test starts. Special guides are supplied to center the sample correctly. The guides can be replaced when another test width is required. The wide workbench enables you to easily perform your tests. The auto detect option leaves your hands free to slide in your sample. The touchscreen has clear buttons makes navigation quick and easily. As an option, the instrument can be adapted for wet test according to ISO 12625-5.

Test Results. After the tests the values are shown in a graph and in statistical values. The main results are force, strain, T.E.A, elongation and force, and there is a wide range of other results. The instrument is equipped with an overload protection and can be supplied with a 50, 100, 250, 500 or 1,000N load cell.

The Novasina Differential Pressure products offer precise and reliable solutions for monitoring and calibrating low differential pressures in clean rooms, HVAC systems, and filter systems with high accuracy and long-term stability.

The 6MBA is the basic model offered within the Ray-Ran Range of Melt Flow Indexers. The manually operated test procedure is very simple to undertake. Molten Polymer is extruded through a closely controlled orifice (die) from the apparatus using pre set conditions of temperature and pressure produced by a dead weight system. The extruded polymer is cut off manually and is then weighed. Using the time interval to extrude the polymer its flow rate over 10 minutes can easily be determined, thus giving the Melt Flow Index (MFI) or Melt Mass Flow Rate (MFR) in g/10 min. By conducting a simple Density Test at test temperature on the same material using the same pre set conditions and a known piston travel distance the Melt Volume Rate (MVR) can also be determined.