Seta – Oil Test Centrifuge – 4 place Centrifuge
This purpose-made Oil Test Centrifuge is fully programmable allowing automatic configuration to the specified oil test parameters. A four place swing out rotor and universal bucket assembly accommodates low cost adaptors and cushions suitable for borosilicate glass centrifuge tubes of the types specified for oil testing: 6 or 8 inch conical, 8 inch trace sediment, 8 inch pear-shaped or 12.5ml. To reduce errors in measurement of tube content, the rotor design allows tubes to stand in a near upright (vertical) position at rest.
Technical Specifications
| Maximum Relative Centrifugal Force (RCF) | 2214g |
| Maximum Rotational Speed | 3000 rev/min |
|---|---|
| Temperature Range | 30 to 80°C ±1°C at 60°C |
| Timer Range | 10 seconds to 59 minutes 50 seconds (10 second steps) up to 1 hour run time. After 1 hour run time the centrifuge run time is 1 hour to 99 hours 59 minutes (only 1 minute steps are possible). Continuous running until manually stopped |
| Control | Microprocessor with 99 memory capacity |
| Capacity | 4 Samples |
| Voltage range | 220/240V, 50/60Hz (Optional transformer for 110/120V) |
| Power | 950W |
| Dimensions (H x W x D) / Weight | 40.1 x 56.41 x 63.93cm 72.5kg |
Key Features
Oil Test Centrifuge
- Conforms to safety requirements IEC 1010-1; 1010-2-D
- 4 place swing out rotor
- Static, near vertical bucket positioning
- Specifically designed for testing oils
- Heated chamber, ambient to 80°C
- Membrane ‘touch’ control panel
- Pre-heat facility to ensure bowl is at test temperature prior to test
- Universal buckets for 12.5ml, 6 and 8 inch glassware
- Optional ‘Setafuge’ Hazard Reduction System
- Microprocessor control with 99 memories
- Optional trolley
Key Industries
- Environmental
- Oil & Gas
- Pharmaceutical
Stanhope-Seta design and manufacture quality control instruments used to measure the physical characteristics that determine product quality and consistency. The…
